Step 3 — Tighten Strengthening Bars
The outer edge of the unit is tied together with strengthening bars. Place the right end of the protective bar on top of the floater tongue. The left end of the protective bar then goes on the bottom of the tongue of the floater to the left. Press a white PVC bolt through the hole from the top. Install a white PVC nut from the bottom. Tighten the assembly using the Dock Blocks wrench.
Be sure to locate the cleats where indicated on the layout. The cleat will replace the white PVC bolt. Press the cleat through the hole from the top, and install a white PVC nut from the bottom.